Elektral ThruScan Manual do Utilizador descarregar pdf (Página 8)

CAUTION! Misuse of this equipment specified by the manufacturer may

result in damage to property or injury to persons.

Technical Specifications:

Electrical : 70 – 270 VAC (Supply should be earthed & stable)

10 Watts standby, 20 Watts max in alarm. A-Class Energy Save

Frequency: 50/60 Hz

Maximum Relative Humidity : 95% non-condensing

Operating Temperature : -20° ~ +70º C

WARNING:

All of the

ThruScan

s and the PC of the SRC-SCADA Remote Control, must be powered at

the same point for the same "ground/earth". Otherwise problems may occur due to

potential difference.

Standards:

The units conform to NILECJ L/1-3 standards

ThruScan is within the magnetic emission limits approved by FDA (American Food & Drug

Administration). It has been certified by experts that has no effects on the peacemakers, the

pregnant women and as well at magnetic media. A “report of expertise” on this issue is presented

in Attachment-1. See Section 10.1.

Protect your ThruScan from direct rain, mist and/or condensation and place water level on a stable

floor without vibration.

DO NOT place the ThruScan close to telephone lines, television monitors, electric motors,

transformers, power cables, or control circuits; excessive electrical noise may cause false

measurements.

CAUTION!

ThruScan

must be firmly anchored to the floor to reduce the accidental risk of

fall down and thus injure persons or cause property damage.

Do not drive nails, screws or drill holes into the side panels.

Screen only when the green “ready LED” is on to ensure proper operation.

Test your apparatus daily especially against environmental displacements.

NOTE:

Security metal detectors are designed to use within a total security-screening

plan. It is the last user’s responsibility to define the overall plan and ensure that

it operates effectively.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 56 57

Sem comentários

Elektral ThruScan Manual do Utilizador Página 8